BKS 2123
Vacuum Cleaner
User Manual
CONTENT
1 Important Safeguards
2 Technical Aspects Of Your Machine
3 How To Use
2
3
4-9
4 How To Clean
10-11
1
1 Important Safeguards
Basic safety Precautions should
always be followed when using
electrical appliances including the
following :
1. If the voltage written under the
label of your vacuum cleaner is
appropriate with the mains voltage
in your house; you can use your
vacuum cleaner. Otherwise motor
may burn.
2. Do not leave your vacuuzm
cleaner plugged. Unplug it when
you do not use or when service is
necessary.
3. Do not use your vacuum
cleaner on wet surfaces and
outside the house.
4. This appliance is not intended
for use by persons (including chil-
dren) with reduced physical, sen-
sory or mental capabilities, or lack
of experience and knowledge,
unless they have been given su-
pervision or instruction concerning
use of the appliance by a person
responsible for their safety.
Children should be supervised to
ensure that they do not play with
the appliance.
5. If the power cord or plug is
damaged, any drop or fall oc-
cured, left outside, get wet or your
device is not working; consult to
authorized services.
7. Do not unplug it by pulling from
its cord. Unplug it by holding from
the plug.
8. Do not touch the plug or the
device with wet hands.
9. Do not drop any objects in to
any open parts of your device.
Make sure that the air passage
holes and channels are open.
10. Keep your hands and hair
away from the working parts of
the machine.
11. Do not use your vacuum
cleaner to clean flammable ob-
jects such as cigarettes, matches,
hot ashes.
12. Do not use your vacuum
cleaner without a paper filter or
other filters are attached.
13. Turn on all of the control
buttons on your vacuum cleaner
before unpluging.
14. Do not vacuum burnable or
flammable liquids. Do not use
your device where these kinds of
liquids exist.
15. Unplug it when attaching or
changing the accessories deliv-
ered with your vacuum cleaner.
16. Do not operate your vacuum
cleaner while keeping it vertical.
17. Small pieces of dust may
cause clog of dust bag. This will
terminate the air passage from
the dust bag. In this case the dust
bag must be changed altough the
dust bag is not completely filled.
6. Do not carry your device by
pulling from its cable. Protect
the cable from sharp edges, hot
surfaces and be careful to not to
closely pressed between a door
and a door frame.
2
2 Technical Aspects Of Your Machine
17
18
19
22
20 21
12345
10
6
7
8
9
16
26
15
23
14
13
11
12
25
24
27
1- Plug and the power cord
2- Brush parking area
3- Cable twisting button
4- On-Off button with power
variator
24- Dust brush
25- Brush park projection
26- Brush control pin
27- Parquet carpet brush
5- Carrying handle
6- Blue indicator light
7- Vacuum control button
8- Dust indicator
9- Front cover
10- Hose inlet
Max. Power : 2300 W
Net weight : 6.6 kg
Voltage and frequency : 220-
240V AC 50 Hz
Dust volume : 4 lt
11- Exhaust filter area
12- Wheel
13- Body protection rubber
14- Front cover opening pin
Usage radius : 9 m
Filtration layer : 7 levels
15- 360 degrees turnable hose
adaptor
16- Elastic hose
17- Handle
18- Air control slide
19- Telescobic extention pipe
20- Upholstery brush
21- Crevice tool
22- Accessories carrying piece
23- Telescobic control pin
3
3 How To Use
Pull the plug and the cable located
at the back, outside; plug it. Stop
pulling when you see the yellow
sign on the cable, red sign comes
after yellow sign, never pull when
you see the red sign. Otherwise
you may give harm to the cable
twister of your product.
Push the on-off button with power
variator in order to operate your
vacuum cleaner. When the on-off
button with power variator is
pushed, the blue indicator light
around the vacuum control button
will be on.
You can control the vacuum
power of your product with the
vacuum power control button
located on the body of your device
while operating.
Note: If your carpet brush sticks
to your carpet because of the high
vacuum power of your product,
you may decrase the vacuum
power by this button.
Push the cable twister button on
the device in order to twist the
cable after the operation of the
vacuum cleaner is finished. Do not
step on the cable twister button.
The mechanism may receive
harm in case of stepping onto it
strongly.
4
You may reduce the vacuum
power a little bit without using the
vacuum power control on your
product, by pulling the slide back
when you want, using the air
control slide on the handle.
Dust indicator
If you preferred to use a cloth filter,
empty the cloth bag and wash in
warm water when the dust indica-
tor shows red. You may use soap
when you wash the cloth bag.
The cloth bag should be inserted
into its place after it is dried for 24
hours. While you are inserting the
cloth bag into its place make sure
that no space is left on the back-
side and fully closed, otherwise
dusts may escape into your motor
and cause harm.
Do not clean by rubbing the edge
of the handle to carpets and coac-
hes, otherwise the edge will melt
and can not be used anymore.
Use the brushes and accessories
delivered with your product for
cleaning.
Dust indicator
It shows the fullness proportion
of your dust bag. If the indicator
shows the red position more
than %50, then it means that the
changing time of the dust bag has
arrived. The dust bag must be
changed altough dust is not col-
lected fully in the dust bag, if slight
pieces of dust is filled the pores
of the dust bag. If the indicator
shows fully red, change the bag
immedeately, otherwise the motor
protector termostate will operate
to terminate your product and
your product will not work for 30
minutes. In this case change the
dust bag, wait your product to get
cold and then operate.
5
Push the bails on the hose adap-
tor and pull it backwards in order
to take the hose adaptor out of the
vacuum cleaner.
You can carry your product by
holding from its handle. If you want
to carry it vertically hold it from the
cavity area for carrying located
below the product.
Picture 1
Picture 2
The hose adaptor of your product
has a property of turning 360
degrees. By this property it pro-
vides an ergonomic usage during
cleaning.
You can attach the hose adaptor
by pushing the hose adaptor in the
direction of the arrow without pus-
hing the nails as shown in picture
1. Make sure that the nails on the
hose adaptor are fitted into their
places as shown in picture 2.
6
The sides and the wheels of your
product is covered with protec-
tive rubber against crashes. By
this way, straching your product
and harming your furnitures are
prevented.
Crevice tool
It can be used in
crevice places such
as interiors of
furnitures and
coaches.
Upholstery brush
It can be used
to clean floor
coverings, steps,
inside of your
car, coaches,
furniture, etc.
How to use the extention pipe
The extention pipe of your product
has telescobic property. In order
to extent the pipe, push the pin
shown in the picture and pull it
from the edge by your hand. You
may arrange its lenght as you
wish.
Dust brush
Dust brush is
used for taking
the dusts of
fragile objects
and curtains.
Pin
How to use the accessories
There is an accessories carrying
adaptor on the extention pipe. You
can use 2 of the accessorieses
you wish by attaching on it. If you
don’t want to use this adaptor,
you can take its screw with a
screw driver and take the piece
out of the telescobic extention
pipe.
7
How to use the parquet, carpet
brush
Do not unplug it immedeately in
order to stop the operation of
your product, first push the on-off
button with power variator to stop
the operation of the product.
There is a control mechanism on
the left side of the parquet carpet
brush. By the help of this control
mechanism the brush is brought
into the desired conditions suitable
for the surface to be cleaned.
You can park
your vacuum
cleaner in two
different ways:
a. In order to clean the rugs and
the carpets, use your brush in
normal condition. (Hair brushes
are hidden.)
vertical and
b. In order to clean hard floor
coverings such as parquet, vinyl
floor covering, linoleum and flat
surfaces such as walls without
scrating, change the position of
the control mechanism and clean
on the hair brushes.
horizantal. You
can attach the
brushes
parking place
in to the
parking socket at the back of the
product in order to park vertically.
Warning: The carpet brush may
stick to your carpet closely since
the vacuum power of your vacuum
cleaner is very high. For this rea-
son it may cause exhausting arm
and back aches. In order not to
face such a problem, reduce the
vacuum power of the product.
Turning off and parking
The operation of the vacuum cle-
aner is stopped by pushing on the
on-off button with power variator
located on the body.
8
Also you can attach the parking
place at the back of your brush
into the parking socket located at
the back of your product and park
horizontally.
Warning: The dust bags purc-
hased from unauthorised places
other than services and dealers
are not original. The dust bags
which are not original are at very
low quality. For this reason they
are torn in a short time and your
product becomes useless. For the
breakdowns stemmed from using
fake dust bags are considered out
of warranty.
Cloth dust bag
If you use cloth dust bags instead
of paper, you may empty it and
reuse for many times. If the dust
bag in your device is cloth then
take the bag out as explained in
“changing the paper filter”.
Change your dust bag when the
dust indicator glows red or if the
vacuum power of your vacuum
cleaner is not at the desired level.
In order to change the dust bag,
first open the front cover by lifting
the pin located in the front. After
opening, take it out by sliding it
up over the cradle where full dust
bag is located. The cover will not
be closed before a new dust bag
is inserted. Please do not force to
close the cover otherwise plastic
sections may harm.
Cloth filter clips
9
4
How To Clean
You can clean cloth dust bags as
fallows:
• Hold the dust bag over a dust
bin upside down. Take the clips off
by pushing to the side.
• Wash the cloth bag in warm wa-
ter by hand. After washing, leave
it to dry and never use before it is
completely dried.
• Close the bag by pushing the
clips on the lower edge of the bag.
If you are using a cloth bag we
recommend you to change the
motor filter once a year.
How to clean the motor filter
When the motor protection filter is
extremely dusted, take it out and
clean.
Also take the motor protection
filter out and shake every time
when the dust bag is changed.
Buy a new motor protection filter
from the service and change once
in every 5 paper filter change.
Otherwise filter looses its effection
since it finishes its usage life. On
the other hand it may cause the
motor to work louder and live
shorter. Motor protection filter
does not have a property such as
being washed, it looses its effects
when washed and causes the
motor to be harmed.
Motor protection
filter
Filter casette
10
Taking off the exhaust cover and
exhaust filters
Hepa filter
On every fifth change of dust bag,
with the change of motor protec-
tion filter; open the exhaust cover
at the back where the air gets out
of your product, by pushing on
the pin as shown in the picture in
order to take the hepa filter and
sponge filter located inside.
Sponge filter
Wash the hepa filter and the spon-
ge filter in warm water and leave
them to dry for 24 hours.
Attention! Do not use devices such
as hair dryers or stoves which give
hot air out in order to dry.
Do not insert the hepa filter and
sponge into their places befo-
re they are completely dried,
otherwise humidity odour may be
delivered, water splash may occur
at the backside and filters may be
harmed.
11
|
