Wireless - N
Broadband Router
Quick Installation Guide
Model # AWN-11N-RT
Back Panel Connectors
Button/Port
Description
Reset
Reset configurations to default. You would use the reset button only when
a program error has caused your 11n AP router to hang. Press the button
and hold for 10 seconds.
WPS
Click WPS button about 2-3 seconds while you are connecting a PC of
wireless adapter with WPS function (you must enable WPS’ PBC
function).
LAN
(1x, 2x, 3x, 4x)
WAN
Ethernet RJ-45 connector, connect to PC with a RJ-45 Ethernet cable.
Ethernet RJ-45 connector, connect to WAN access device, such as the
Cable modem or ADSL modem.
PWR
Power connector, connect to the power adapter packaged with the AP
router.
1.4 Installation Instruction
1) Power off 802.11n AP Router and DSL/Cable modem.
2) Connect computer to the LAN port on the Wireless Router with Ethernet cable.
3) Connect the DSL or Cable modem to the WAN port on the Wireless Router with
Ethernet cable.
4) Power on DSL or Cable modem first, then connect power adapter to the power jack on
the rear panel of Wireless Router and plug the power cable into an outlet.
5) Check LEDs.
a) Once power on Wireless Router, Power LED should be on.
b) LAN LED should be on for each active LAN connection.
c) The WAN LED should be on when the DSL or cable modem is connected.
Warning: Only use the power adapter is provided from this package, use other power
adapter may cause hardware damage
2
|