Press S2 (upper right) to cycle through
the fields you can set.The fields are: Time
setting → Alarm On/Off → Time setting.
Press S2 until you see digits in the center
of the display. Now you can set the timer.
Press S3+ (lower right) to increase the
timer set point, and press S3– (lower left)
to decrease the set point.You will see both
the digits and also the dial size increase or
decrease. For a setting of 60 minutes, the
dial will show completely red.
Back light
and Setting
TIME TIMER
0
Start,
Stop, &
Reset
Wrist Timer™
“the difference is the disk”
30
Timer
30M
WATER RESIST
TIMER Button
Press Once to
Start andTwice
quickly to Stop.
Once you have set the desired time, press
S2 once to change Alarm On/Off Setting.
Introduction
TIME TIMER
Congratulations on your purchase of the
TimeTimer WristTimer! No other tool
communicates the concept of elapsed
time as well as theTimeTimer.Time
Timer reinforces the sense of elapsed
time with a graphic depiction of the time
remaining.
You will see the word “ON” or “OFF,” plus
0
•
an alarm
3 symbol, both flashing. Press
S3+ or S3– to turn the Alarm on or off.
Press and
Hold to Reset.
Pressing S2 again will return you to the
Timer setting. Press S4 once (upper left)
to exit setting mode. Leaving the timer
unattended for 30 seconds in set mode
causes it to save any changes and then exit
set mode.
30
30M
WATER RESIST
Understanding the Timer
TheTimeTimerWristTimer™ provides
a graphical count down timer, using the
patentedTimeTimer technology. Red
represents the time remaining.The disk
diminishes as time elapses until the
display is blank and no red is visible on
the timer face.Time elapses in a clockwise
direction. When active, the Alarm sounds
to let you know that time has run out.
• To Start the timer, press theTIMER
Setting Notes:
button (upper right).
1. You can either press and release S3+
and S3– to change field values, or “press
and hold” either of the S3 buttons to
rapidly change the field value.
2. You can return to the default timer
setting of 60 minutes by simultaneously
pressing S3+ and S3–.
• To Stop the timer, press theTIMER button
TWICE, in rapid succession (press the
button twice within ½ second).
• To Reset the timer, press and hold the
TIMER button for at least 2 seconds.
If turned ON, the Alarm will sound
when time expires.The alarm sounds
for 5 seconds, or until cancelled by
pressing any button.
TIME TIMER
TIME TIMER
TIME TIMER
Changing the Battery
0
0
0
When the display grows dim or goes out
entirely, it is time for a new battery. Using
a small Phillip’s head jeweler’s screwdriver,
remove the four screws holding back of
timer onto case. Gently slide the old battery
from its slot, and replace with new CR2025
Lithium battery. Make sure that the positive
(“+”) terminal side is facing up.
Setting the Timer
The timer must be stopped before changing
settings.The timer uses a standard setting
procedure:
30
30
30
30M
30M
WATER RESIST
30M
WATER RESIST
WATER RESIST
45 minutes
remaining
59 minutes
remaining
Time’s up
• Press and hold “S1” to enter setting mode
• Press “S2” to change the field to set
• Press “S3” to change the value of the
field being set
• Press “S4” to exit setting mode
To set the timer, press and hold the
S1 button (upper left) for about three
seconds, until the numbers in the middle
begin to flash, indicating that you have
entered setting mode.
Power Reset
The timer also comes with a convenient
back light, to help you see the display
in low light conditions. Press the LIGHT
button (upper left) to turn on the back
light.
You can reset the timer to original factory
settings by pressing S3+ and S3– (the two
lower buttons) together, and holding for at
least five seconds.
Manufactured for
TimeTimer, Inc.
7707 Camargo Road
Cincinnati, OH 45243
Using the Timer
S1 & S4
S2
The timer can be set anywhere from one
minute up to one hour.There is an
audible alarm to let you know when time
has expired.
TIME TIMER
0
(513) 561-4199
Fax (513) 561-4699
.
The timer comes from the factory set
to one hour, and the audible alarm set
to OFF.
Alarm is On
S3+
1-877-771-TIME
(1-877-771-8463)
30
30M
WATER RESIST
To change the settings, see the following
instructions.
S3–
U. S. PATENT NO. D369, 619 & 5,662,479
REGISTER NOW. Please return your AX810T registration to the Repair
Center address in the warranty, and we will let you know about future products.
5 YEAR NO-PROOF-OF-PURCHASE LIMITED WARRANTY
Free service for first year (see back of watch for date). $15 fee applies
thereafter. Return unit with daytime phone number to: AST Repair Center,
3090 Independence Drive, Suite 148, Livermore, CA 94551 USA 800-935-1996
Email ___________________________________________________
User ____________________________________________________
Developed by Time Timer LLC, in cooperation with Abilitations,
“improving the lives of children with special needs”
#998-311A
|